User guide

76 Tempest®24 00 4-Channel Wireless Intercom System
BeltSta on
BeltSta on will not power up
• Con rm that ba ery(ies) is (are) installed correctly.
• When using a Lithium-Polymer rechargeable ba ery, ensure that the ba ery is fully charged.
• When using alkaline AA ba eries, ensure that ba eries are fresh and are all facing the same way. Note the illustra on
in the ba ery compartment sec on.
• Press and hold the Power bu on on the back of the BeltSta on for two seconds to power ON.
BeltSta on will not pair with BaseSta on
• Con rm that the BaseSta on you are pairing with is powered ON and in Opera onal Mode, and the BeltSta on is
powered OFF. Connect the pairing cable from the BaseSta on to the BeltSta on. Turn the BeltSta on power ON.
The pairing process takes approximately four seconds.
• If pairing is successful, the message “Pairing Complete” will appear on the BeltSta on LCD for approximately  ve
seconds and the BeltSta on name will appear in the  rst available slot on the BaseSta on LCD. The BaseSta on
name will appear on the BeltSta on LCD. If pairing is not successful no message will appear.
• If pairing is not successful, try to pair a di erent BeltSta on with the BaseSta on. If neither of the BeltSta ons
will pair, subs tute a new Pairing cable.
• If successful pairing any BeltSta on with the BaseSta on, try the following procedure on the BeltSta on that will
not pair:
» Restore memory se ngs to Factory Defaults by pressing MENU
» Select “Belt Se ngs,” select “Tech Menu,” press ENTER to proceed
» Select “Set Defaults,” select
Restore Factory Defaults, press ENTER to con rm and press MENU to exit
• If s ll not successful, repeat the above procedure but select
Clear Memory to delete all memory se ngs, pairings,
and user se ngs. See “Factory Defaults” sec on for more detail.
• If no BeltSta on will pair with the BaseSta on, reset the BaseSta on memory to “Factory Defaults”.
• The  nal op on is to select “Clear Memory” to fully reset the BaseSta on. All BeltSta on pairings will be lost with the
“Clear Memory” op on. See “Factory Defaults” sec on for more detail.
BeltSta on will not log into BaseSta on
• Con rm that the BeltSta on is powered ON and has a ba ery with ample charge.
• Con rm that the proper BaseSta on is selected on the BeltSta on’s “Select Base” menu.
• Con rm that there is an available slot on the BaseSta on.
• Check Sta c and Dynamic slot display se ngs on the BaseSta on. If Sta c is selected check the BeltSta on slot
assignment.
• Determine if any BeltSta on is logged onto the BaseSta on.
• Re-pair the BeltSta on to the BaseSta on.
• A empt to log into another BaseSta on, if available.
• Follow the memory reset procedure under “Factory Defaults.”