User guide

72 Tempest®24 00 4-Channel Wireless Intercom System
Con gure Relays for Individual BeltSta ons
From the BeltSta on:
• Press MENU; select “Set Controls,” select “Select Relay.” Note that there are more op ons under “Set Controls”
than  t on the screen. Scroll to the bo om of the screen and scroll one more detent to see the “Select Relay”
op on. Select one of the relays: Relay 1 thru Relay 5. When a relay is selected a check mark will be visible beside
the selec on.
• To ac vate the relay, a “Relay Bu on” must be triggered. To select a “Relay Bu on,” one of the relays must
already have been selected. To select a “Relay Bu on,” Press MENU, select “Set Controls,” select “Relay Bu on,”
select one of the trigger op ons.
• If Talk A/B or Talk C/D is selected to ac vate the relay, the relay will remain closed whenever the bu on is
selected for ac ve talk.
• If Ch A/B or Ch C/D is selected to ac vate the relay, the relay will remain closed whenever a channel is selected.
• If STAGE, ENTER, or CALL is selected to ac vate the relay, the relay will remain closed whenever the bu on is
pressed, for as long as the bu on is held.
» If STAGE is selected to ac vate the relay, and if Stage Announce Audio is enabled, and if the Stage Announce
Relay is enabled, all three func ons will operate simultaneously.
» If ENTER is selected to ac vate the relay, and if Wireless ISO is enabled, both func ons will operate
simultaneously while in Opera onal mode. When in Menu mode, ENTER only func ons as an Enter bu on.
» If CALL is selected to ac vate the relay, and the CALL feature is enabled, both func ons will operate
simultaneously.
From the BaseSta on:
• Select the numbered key 1 through 5 that corresponds to the BeltSta on desired. Scroll to and choose “Select
Relay.” Select one of the relays Relay 1 thru Relay 5.
• Press MENU to go up one level back to the menu.
• Scroll to and select “Relay Bu on;” select an op on to trigger the relay.
Since every user will require a custom applica on, cables for your RELAY connec ons will require some bench work
with a soldering iron.
Use the Transceiver
Choose an op mum loca on for the Tempest Remote Transceiver and antennas.
Using standard CAT-5 cable, connect the Transceiver to the BaseSta on RJ-45 connector labeled TRANSCEIVER.
The “Power” LED on the Transceiver will light if the BaseSta on is powering the unit. If the “Power” LED does
not illuminate when connec ons are made and the BaseSta on is ON, the CAT-5 cable may be too long to deliver
adequate power to the Transceiver.
Local BaseSta on whip antenna is disabled when the remote transceiver is connected.