User guide
69 Tempest®24 00 4-Channel Wireless Intercom System
Coverage Planning
Placing your antennas for Tempest Seamless Roaming follows the same basic rules of any mul -BaseSta on Tempest
wireless system with one excep on. The antennas do not need to be located in the same physical loca on. For example,
let’s look at a two BaseSta on system u lizing two Remote Transceivers:
A venue has two large rooms separated by a hallway. Each room needs Tempest coverage and the ability for users to work
and move freely from room to room. Note: Up to 11 BaseSta ons can be u lized with Seamless Roaming providing 11 overlapping
coverage areas.
Implementa on
BaseSta on Confi gura on
• Verify ALL the BaseSta ons in the system con gura on are properly connected to the same ZSync source, and
assure that source is receiving power. See the ZSync sec on of this manual for more informa on on ZSync
technology.
• Verify ALL BaseSta ons have Network Numbers within the same Network Number group (i.e. 0,1,2,3...10 or 11, 12,
13, 14...20.) See the sec on on Network Number groups in this manual for more informa on.
• Verify ALL BaseSta ons in a Roaming Group are set with the same Lockout Key
• Verify ALL BaseSta ons in a Roaming Group are opera ng in the same opera onal mode: Normal, Shared or Split.
• Verify ALL BaseSta ons have the same audio sources across all used channels (if desired); if the BaseSta ons are not
connected to an external hardwired system, assure that one BaseSta on is in Master Mode. See the Master Mode
sec on of this manual for more informa on.
BeltSta on Confi gura on
• Using a pairing cable, pair all BeltSta ons to each BaseSta on they are intended to roam with.
• Set up each BeltSta ons Roaming Group (up to 16 BaseSta ons may be selected per BeltSta on)
• Enable Roaming on each BeltSta on; when roaming is not enabled, a BeltSta on will operate as normal on a single
BaseSta on.
• Adjust Roaming Bias se ng (if needed). See the sec on on BeltSta on Setup in this manual for more informa on
on adjus ng Roaming Bias in Seamless Roaming.
Placing one BaseSta on’s Remote Transceiver in the center
of one room, and placing the second BaseSta on’s Remote
Transceiver in the center of the other room will provide
coverage for both of those spaces.
By adjus ng the loca on of the two Remote Transceivers
closer to one another, the area of overlapping coverage can
be increased. In this case, providing be er coverage for the
hallway in between the two rooms.