User guide

42 Tempest®24 00 4-Channel Wireless Intercom System
BeltSta on Setup
Steps to Setup the BeltSta ons
Install the ba ery.
“Pair” BeltSta ons to the BaseSta on.
Adjust slot se ngs as needed.
Connect a headset.
Adjust Mic Gain.
Adjust Sidetone.
Con gure op onal features:
» Name the BeltSta on.
» Disable unused func ons, channels, and bu ons.
» Select/disable relay op ons as needed.
» Adjust personal preferences.
Ba ery Selec on and Installa on
The Tempest BeltSta on Ba ery Compartment holds either one Tempest Lithium-Polymer rechargeable ba ery or three
standard alkaline AA cells. Lithium-Polymer ba eries are the primary power source. High quality alkaline AA cells may be
used in situa ons where Lithium-Polymer ba eries are not available or are not charged. One Lithium-Polymer ba ery
comes standard with each Tempest BeltSta on. Addi onal Lithium-Polymer ba eries may be purchased. Contact your
dealer or distributor to purchase addi onal ba eries. The Lithium-Polymer ba eries supplied with your Tempest Wireless
system are warranted for 90 days from the date of purchase.
Lithium-Polymer ba eries o er up to nine hours of ba ery life and recharge in
approximately 2¾ hours.
Lithium-Polymer ba eries ship from the factory with approximately 50% charge. It
will not damage the Lithium-Polymer ba eries to use them without charging them
rst. This will, however result in shorter run  me un l the Lithium-Polymer ba ery
is fully charged. When possible, charge Lithium-Polymer ba eries to full capacity to
ensure full ba ery life prior to use.
Using (3) alkaline AA ba eries can provide up to four hours of ba ery life. Use
only high quality alkaline AA cells. This will provide enough me to fully charge the
Lithium-Polymer ba ery.
To remove the ba ery door, press down on the thumb markings and pull the ba ery door toward the bo om of the
BeltSta on.
To remove ba eries from the ba ery compartment, turn the BeltSta on ba ery side down and tap the bo om of the
BeltSta on on the palm of your other hand.
Please be careful to insert alkaline AA ba eries according to the marked polarity. All of the alkaline AA cells must be
oriented the same direc on.
If the ba ery cover does not close properly, the ba ery may not be inserted correctly.