User guide
36 Tempest®24 00 4-Channel Wireless Intercom System
BaseSta on Headset Connec on and Controls
The BaseSta on headset connec on is a func onal user communica on point, and may also be used for setup and
troubleshoo ng. The Front Panel Headset can communicate on any one of the four intercom channels. Controls for this
headset are located just to the right of the connector, and in the menu on the BaseSta on Se ngs screen.
The front panel headset connector is a 4-PIN XLR male. A compa ble headset must be provided by the user.
The TALK bu on enables or disables the microphone for the local headset. A blue LED will backlight the word “TALK” on
the TALK bu on when the mic is enabled. Always keep the microphone disabled (TALK OFF) when not in use.
Tempest uses an intelligent latching method for TALK bu ons. Pressing the TALK bu on momentarily (less than two
seconds) will latch the mic bu on. The blue “TALK” LED will remain lit and the microphone will remain enabled. Pressing
and holding the TALK bu on will cause the bu on to act in a momentary or push-to-talk fashion, so the blue “TALK” LED
will remain lit and the microphone will remain enabled only as long as the bu on is pressed.
In Opera onal Mode, turning the Volume control adjusts the volume of the audio of the local headset. Turning the
Volume control clockwise increases the audio level while turning the control counter clockwise decreases the level. The
Volume control knob is also a push bu on. Pressing the Volume control cycles the Channel selec on and LEDs in order
from A through D.
The four Peak LEDs indicate when the mic audio from the local headset is reaching a peak level and is about to enter into
limi ng. These LEDs should normally be OFF.
Set the Mic Gain for the Local Headset
Set the Mic Gain properly to assure the best audio quality. To set the Mic Gain for the Local Headset:
1. Press MENU to enter Menu Mode.
2. From the Main Menu select “BaseSta on Se ngs,” then “Set Mic Gain.”
3. While at the “Set Mic Gain” screen, talk into the local headset microphone in a louder than normal level and adjust the
Volume control un l the Peak LED for the selected channel just starts to light at the loudest parts of the audio. Press ENT to
accept the changes.
When the Mic Gain is set too high, it is possible to induce feedback or echo. When set too low, words can be clipped
by the low level noise gate, or may sound too quiet to other listeners. Headsets by di erent manufacturers or di erent
models of headsets will require widely varying Mic Gain se ngs. When se ng microphone gain, it is best to err toward
a se ng that is too low, rather than too high. This will help reduce unwanted echo in the system when that microphone
is enabled.