User guide

22 Tempest®24 00 4-Channel Wireless Intercom System
Bo om view of the transceiver
Transceiver Controls
1- RX LED
The RX LED illuminates when data is being received by the Remote Transceiver. This LED will remain illuminated during
normal system opera on.
2- TX LED
The TX LED illuminates when data is being sent from the Remote Transceiver. This LED will remain illuminated during
normal system opera on.
3- SYNC LED
The Sync LED illuminates when the Transceiver Sync signal is present. This LED will remain illuminated during normal
system opera on.
4- CONFIG LED
The Con g LED illuminates only when the BaseSta on puts the Remote Transceiver into con gura on mode to change
se ngs. This LED should be ON for only a few seconds when  rst powered ON, and OFF during normal opera on.
5- BASESTATION LINK RJ-45 Connector
The BaseSta on Link RJ-45 connector is used to connect the Transceiver to the Tempest BaseSta on via standard CAT-5
cable with RJ-45 connectors.
6- Power LED
The Power LED illuminates whenever the BaseSta on is providing adequate power to the Transceiver over the CAT-5 cable.
If the Power LED does not light, the CAT-5 cable may be damaged or too long to deliver adequate power for the Transceiver
to operate reliably.
Threaded Moun ng Holes
Two Threaded Moun ng Holes are provided on the back of the Remote Transceiver for use with the moun ng bracket to
mount the Transceiver in a convenient loca on. The moun ng holes are #8-32 thread and accept a #8-32 x 3/8” pan head
screw.