User guide

21 Tempest®24 00 4-Channel Wireless Intercom System
Talk Bu on A/B and C/D
There are two TALK bu ons on each BeltSta on, one for
channels A/B and the other for channels C/D. The Talk bu on
enables the microphone signal for the assigned intercom
channels.
Tempest uses an intelligent latching method for TALK bu ons.
Pressing the TALK bu on momentarily will cause the TALK
bu on to latch. Pressing and holding the TALK bu on will
cause the bu on to act as a momentary switch.
Talk tones can be enabled or disabled per BeltSta on. If
enabled, users will here a tone each  me the TALK bu on is
pressed.
Channel Indicator LEDs A/B and C/D
Each Talk bu on has four individual LED indicators. Together they surround the
Talk bu on. The LEDs will fl ash blue to indicate which intercom channel, A, B, C,
or D, has been selected and will illuminate con nuously to indicate that “Talk”
is enabled on that channel.
The Channel Indicator LEDs will fl ash red when the microphone signal is reaching
a peak level and is entering into limi ng.