User guide

18 Tempest®24 00 4-Channel Wireless Intercom System
6- Local Area Network (LAN) RJ-45 Connector
The Local Area Network (LAN) RJ-45 Connector is used to connect the Tempest BaseSta on to a user supplied PC running
Tempest Desktop Con gura on (T-Desk) so ware. The user can then monitor and/or adjust BaseSta on and BeltSta on
se ngs via the PC interface. This connec on can be made directly or through a Local Area Network (LAN).
See the separate
T-Desk User Manual for more informa on.
7- Relay Connector
The Relay Connector provides access to all of the relay closure contacts for the Tempest BaseSta on. There are six
relays including one common Stage Announce relay and  ve individually assignable relays - one for each of the wireless
BeltSta ons. See the sec on on “GPO Relay Contacts.
8- Antenna Connector
The Antenna Connector is used to connect the antenna to the Tempest BaseSta on. The Antenna Connector is an RP-TNC
(Reverse Polarized-TNC) connector. Cables used to a ach to this Antenna Connector must be properly terminated with
ma ng RP-TNC connectors and the proper cable type.
9- Remote Transceiver RJ-45 Connector
The Tempest Remote Transceiver RJ-45 connector is used to connect the op onal remote transceiver to the Tempest
BaseSta on. The remote transceiver can be located up to 1,500 feet from the BaseSta on.