User guide

6 Tempest®24 00 4-Channel Wireless Intercom System

Quick Start Guide

What You Will Need

BaseSta on

» Power cord

» Two BaseSta on antennas

» 3.5mm male-to-male mini-stereo

pairing cable

BeltSta ons

» Up to 5 per BaseSta on

» Lithium-Polymer ba ery and

» Charger - 1 per BeltSta on

Headsets (customer supplied)

» 1 per BeltSta on

» 1 per BaseSta on

1. Connect two whip antennas onto the back of the BaseSta on.

Select a suitable loca on for the BaseSta on. Tempest is a radio system, broadcas ng and receiving RF signals that are

a ected by physical and electronic barriers.

The antenna should be located as high as possible and away from all obstruc ons. When using whip (omni-direc onal)

antennas, select a loca on as close as possible to the center of the area you want to cover.

Use alterna ve antenna op ons when the BaseSta on is in a rack or other metal structure, or stacked with other gear.

Remote loca on antenna placement of up to 1,500  . can be achieved using the Tempest Remote Transceiver. See the user

manual for more details about antenna placement, recommended cable types, and other antenna op ons.

2. Connect the power cord and Power On the BaseSta on.

3. Install Ba eries in BeltSta ons

Install the Lithium-Polymer ba ery in each BeltSta on. Be certain that the gold

contacts on the ba ery touch the contacts in the ba ery compartment. The ba ery

is shipped with a par al charge, so charging will be necessary before maximum run

 me will be achieved.

Insert (3) AA alkaline ba eries in the ba ery compartment. Always replace the

ba ery cover.

To power ON the BeltSta on, press and hold the power bu on for approximately

two seconds. The display will indicate “None Selected.” Turn the power OFF by

holding the power bu on for four seconds.