Specifications

V. CS-210
SPECIFICATIONS
AMPLIFIER
DESIGN:
IC amplifiers includi ng solid-state
switching and signal
ling circuits.
Current-limited
and short-circuit
protected.
MICROPHONE
PRE-AMP:
PROGRAM AMPLIFIER:
Input:
Low impedance
(Ik
ohm) for
Gain,
input
to intercom
line,
max.:
200 ohm
nominal dynamic
elements
+49
dB (mic),
-1 dB (line)(the
gain
Input
Level: -55 dBv nominal,
to headset output is a max. of
-10
dBv max. before
clipping*
37 dB
more than to
intercom line)
Nominal
Gain:
+37 dB
Frequency
Response:
150-18k
Hz
Freq. Response:
250 Hz-12kHz
with a I nput
Impedance:
3.6k balanced
contoured response
to (mic),
300k ohms balanced
(line)
enhance voice
intelligibility
Input Level:
-75 dBv nominal (mic),
Gain Adjust: +5 dB
-15 dBv nominal (line),
Limiter Range: 25
dB max. before clipping;
Volume
full on,
-52 dBv (mic),
+3 dBv (line)
HEADPHONE
AMPLIFIER:
Drives any load of at least 150 POWER SUPPLY:
ohms
to full output
(+18 dBv)
Output Voltage:
30 VDC,
regulated
Distortion:
<0.2% THD at
1kHz Output
Current:
i amp max.
Gain from intercom line: +37 dB max Channel
Separation: >50 dB
Frequency
Response: 150-18kHz +2 dB Signal-to-Noise:
>55 dB
OPERATING CONDITIONS
Channel Monitoring: Push-button-selectable
A, B, or both
Call Circuitry: Receives
a signal from remote stations whether or
not channel
is monitored. The Call button sends a signal only
on channel(s) being monitored.
Capacity:
Will support up to 60 headset stations or 12 speaker stations.
System Impedance: 200 ohms,
internally terminated (jumper-removeable)
System Level: -18 dBv nominal;
0 db before clipping*
Signallingi: Call Light Sensitivity--4
VDC max.; Call Voltage--11 VDC min.
Stage Announce: balanced, line-level (0 dBv) transformer-isolated 600 ohm out-
put from mic pre-amp
CONNECTORS
Headset: (2) XLR 4-pin male
Channel Outputs: (6) XLR 3-pin male
Stage Announce: (1) XLR 3-pin male
Program Input: (1) XLR 3-pin female
Ext. Speaker: 1/4" mono phone jack
POWER REQUIREMENTS
105-125 or 210-250 VAC;
50-60 Hz, switch-selectable from rear panel; 60 watts max.
DIMENSIONS
3-1/2" H x 9-11/16"
W x 11-11/16" D (front to back)
(89 mm x 254mm x 305mm)
ENVIRONMENTAL TOLERANCE
0-50 degrees C (32-122 degrees F)
* 0 dBv is referenced to 0.775 volts RMS.
20