User Manual
Table Of Contents
- 1 Important Safety Instructions
- 2 Introduction
- 3 Installation Overview
- 4 Locating System Components
- 5 Powering System Components
- 6 Wiring System Components
- 6.1 Using RJ-45 connectors
- 6.2 Connecting the matrix frame to a PC running EHX
- 6.3 Connecting the matrix frame to an Ethernet network
- 6.4 Connecting the matrix frame to a PC running Production Maestro Pro
- 6.5 Connecting the matrix frame to user panels
- 6.6 General Purpose Outputs (GPOs)
- 6.7 General Purpose Inputs (GPIs)
- 6.8 E & M signalling with an E-QUE E1 / T1 interface card
- 6.9 Connecting the matrix frame to an external alarm
- 6.10 Connecting to a four-wire audio device
- 6.11 Connecting to interface modules
- 6.11.1 Wiring schemes for the FOR-22 interface module
- 6.11.2 Wiring schemes for the CCI-22 interface module
- 6.11.3 Wiring for Clear-Com analog partyline systems (including Encore)
- 6.11.4 Wiring schemes for TEL-14 interface modules
- 6.11.5 Wiring scheme for the RLY-6 interface module
- 6.11.6 Wiring schemes for a GPI-6 Interface module
- 7 Connecting Matrix Frames
- 8 Glossary
7 Connecting Matrices
(Matrix frames)
Provides information on connecting different matrices
(matrix frames) together.
Table 1: Chapters summary
2.2 Further information
For more information about any of the Eclipse HX system components (devices) referenced
in this guide (including matrix frames, interface cards, interface modules and software), see
the specific documentation for that device or software.
Eclipse HX documentation is available from:
• Your product DVD-ROM.
• The Clear-Com website (http://www.clearcom.com/product/digital-matrix
).
For sales information, see your Clear-Com sales representative. For contact information, see
Page 2 of this guide.
9
Eclipse HX Matrix Frame Installation Guide