User Manual
Table Of Contents
- 1 Important Safety Instructions
- 2 Introduction
- 3 Installation Overview
- 4 Locating System Components
- 5 Powering System Components
- 6 Wiring System Components
- 6.1 Using RJ-45 connectors
- 6.2 Connecting the matrix frame to a PC running EHX
- 6.3 Connecting the matrix frame to an Ethernet network
- 6.4 Connecting the matrix frame to a PC running Production Maestro Pro
- 6.5 Connecting the matrix frame to user panels
- 6.6 General Purpose Outputs (GPOs)
- 6.7 General Purpose Inputs (GPIs)
- 6.8 E & M signalling with an E-QUE E1 / T1 interface card
- 6.9 Connecting the matrix frame to an external alarm
- 6.10 Connecting to a four-wire audio device
- 6.11 Connecting to interface modules
- 6.11.1 Wiring schemes for the FOR-22 interface module
- 6.11.2 Wiring schemes for the CCI-22 interface module
- 6.11.3 Wiring for Clear-Com analog partyline systems (including Encore)
- 6.11.4 Wiring schemes for TEL-14 interface modules
- 6.11.5 Wiring scheme for the RLY-6 interface module
- 6.11.6 Wiring schemes for a GPI-6 Interface module
- 7 Connecting Matrix Frames
- 8 Glossary
Figure 37: Fiber optic connected matrices (matrix frames)
TX2- E-FIB
card#1 - RX2
TX2- E-FIB
card#1 - RX2
TX2- E-FIB
card#1 - RX2
TX
2- E-FIB
card#1 - RX2
TX2- E-FIB
card#1 - RX2
TX
1- E-FIB
card#1 - RX1
TX
1- E-FIB
card#1 - RX1
TX1- E-FIB
card#1 - RX1
TX1- E-FIB
card#1 - RX1
TX
1- E-FIB
card#1 - RX1
System #1 System #2 System #3
System #4System #5
Primary ring
Secondary ring
83
Eclipse HX Matrix Frame Installation Guide