User Manual
Table Of Contents
- 1 Important Safety Instructions
- 2 Introduction
- 3 Installation Overview
- 4 Locating System Components
- 5 Powering System Components
- 6 Wiring System Components
- 6.1 Using RJ-45 connectors
- 6.2 Connecting the matrix frame to a PC running EHX
- 6.3 Connecting the matrix frame to an Ethernet network
- 6.4 Connecting the matrix frame to a PC running Production Maestro Pro
- 6.5 Connecting the matrix frame to user panels
- 6.6 General Purpose Outputs (GPOs)
- 6.7 General Purpose Inputs (GPIs)
- 6.8 E & M signalling with an E-QUE E1 / T1 interface card
- 6.9 Connecting the matrix frame to an external alarm
- 6.10 Connecting to a four-wire audio device
- 6.11 Connecting to interface modules
- 6.11.1 Wiring schemes for the FOR-22 interface module
- 6.11.2 Wiring schemes for the CCI-22 interface module
- 6.11.3 Wiring for Clear-Com analog partyline systems (including Encore)
- 6.11.4 Wiring schemes for TEL-14 interface modules
- 6.11.5 Wiring scheme for the RLY-6 interface module
- 6.11.6 Wiring schemes for a GPI-6 Interface module
- 7 Connecting Matrix Frames
- 8 Glossary
Figure 36: T1 Trunking using a E1 Network
E1/T1 trunking failover
Where the E1/T1 trunking has been configured with redundant trunks audio will be switched
from the primary trunk to the backup trunk when a failure is detected.
When failover occurs from primary to backup there will be a three second audio break on
any route running over the trunk.
If the trunk routing is later switched back from the backup trunk to the primary trunk there will
be no loss of audio.
7.5 Fiber-optic linking
The E-FIB interface card is the fiber-net interface for the Eclipse HX-Omega, Eclipse HX-
Median and Eclipse HX-Delta frames. The card is supplied with main and backup fiber rings.
Tip: For more information about the E-FIB interface card, and other Clear-Com interface
cards, see:
• The Eclipse HX-Omega User Guide.
• The Eclipse HX-Median User Guide.
• The Eclipse HX-Delta User Guide.
81
Eclipse HX Matrix Frame Installation Guide