User Manual
Table Of Contents
- 1 Important Safety Instructions
- 2 Introduction
- 3 Installation Overview
- 4 Locating System Components
- 5 Powering System Components
- 6 Wiring System Components
- 6.1 Using RJ-45 connectors
- 6.2 Connecting the matrix frame to a PC running EHX
- 6.3 Connecting the matrix frame to an Ethernet network
- 6.4 Connecting the matrix frame to a PC running Production Maestro Pro
- 6.5 Connecting the matrix frame to user panels
- 6.6 General Purpose Outputs (GPOs)
- 6.7 General Purpose Inputs (GPIs)
- 6.8 E & M signalling with an E-QUE E1 / T1 interface card
- 6.9 Connecting the matrix frame to an external alarm
- 6.10 Connecting to a four-wire audio device
- 6.11 Connecting to interface modules
- 6.11.1 Wiring schemes for the FOR-22 interface module
- 6.11.2 Wiring schemes for the CCI-22 interface module
- 6.11.3 Wiring for Clear-Com analog partyline systems (including Encore)
- 6.11.4 Wiring schemes for TEL-14 interface modules
- 6.11.5 Wiring scheme for the RLY-6 interface module
- 6.11.6 Wiring schemes for a GPI-6 Interface module
- 7 Connecting Matrix Frames
- 8 Glossary
2 Introduction
The Matrix Frame Installation Guide describes the steps required to install
and configure an Eclipse HX matrix system. The Eclipse HX system is a digital point-to-point
intercom platform, designed to seamlessly integrate your entire intercom infrastructure
(digital, wireless, IP-based and analog intercom systems). The system comprises matrix
frames, interface cards and modules, user panels and interface frames.
The system is configured and managed using the highly intuitive software.
The guide:
• Provides information about placing, powering, and wiring the hardware system
components.
• Defines many of the concepts used in the system.
Tip: For more information about , see your EHX documentation, including EHX Help
(integrated with your software).
Servicing instructions are for use by qualified personnel only. To reduce
the risk of electric shock, do not perform any servicing other than that
described by this guide, unless qualified to do so. Refer all servicing to
qualified service personnel.
2.1 Chapters summary
Chapter
Summary
3 Installation Overview
Provides a step-by-step installation guide for the
components of the Eclipse matrix system, as received
from the factory.
4 Locating System
Components
Describes the environmental / location requirements for
the matrix system components. Includes a summary of
component sizes.
5 Powering System
Components
Provides guidelines for providing AC power to the system
and for planning the powering of interface frames.
6 Wiring System
Components
Provides an overview of the various wiring systems for
connecting panels and interfaces to the matrix. This
chapter contains reference information to help you wire all
connectors in the Eclipse HX system. Information on
internal jumpers, adjustments, and device specifications
can be found in the individual documentation for each
component.
8
Eclipse HX Matrix Frame Installation Guide