User Manual
Table Of Contents
- 1 Important Safety Instructions
- 2 Introduction
- 3 Installation Overview
- 4 Locating System Components
- 5 Powering System Components
- 6 Wiring System Components
- 6.1 Using RJ-45 connectors
- 6.2 Connecting the matrix frame to a PC running EHX
- 6.3 Connecting the matrix frame to an Ethernet network
- 6.4 Connecting the matrix frame to a PC running Production Maestro Pro
- 6.5 Connecting the matrix frame to user panels
- 6.6 General Purpose Outputs (GPOs)
- 6.7 General Purpose Inputs (GPIs)
- 6.8 E & M signalling with an E-QUE E1 / T1 interface card
- 6.9 Connecting the matrix frame to an external alarm
- 6.10 Connecting to a four-wire audio device
- 6.11 Connecting to interface modules
- 6.11.1 Wiring schemes for the FOR-22 interface module
- 6.11.2 Wiring schemes for the CCI-22 interface module
- 6.11.3 Wiring for Clear-Com analog partyline systems (including Encore)
- 6.11.4 Wiring schemes for TEL-14 interface modules
- 6.11.5 Wiring scheme for the RLY-6 interface module
- 6.11.6 Wiring schemes for a GPI-6 Interface module
- 7 Connecting Matrix Frames
- 8 Glossary
Wiring the GPI-6 to the IMF-3 interface frame
To connect the GPI-6 to the matrix frame:
1. Connect one end of an RJ-45 cable (eight wires with no reversal) into the
GPI/RLY INTERFACE connector on the back of the frame.
2. Connect the other end into the top RJ-45 (CH. A MATRIX) connector for the GPI-6.
To connect an additional GPI-6 Interface module:
1. Connect one end of a short RJ-45 cable into the lower RJ-45 (CH. B MATRIX) for
the first GPI-6.
2. Connect the other end of the cable into the top RJ-45 (CH. A MATRIX) connector for
the additional GPI-6.
Additional GPI-6 Interface modules are added in the same way, using daisy-chain wiring. If
there are multiple GPI-6 modules used, the inputs in the first will be numbered 1 to 6, second
will be 7 to 12, etc.
RLY-6 modules can be mixed in this daisy-chained scheme. The maximum combined length
of all the RJ-45 cables should not exceed 20 ft. (6 m).
Wiring the GPI-6 to external devices
To connect external devices to the GPI-6 interface, use the two DB-9M connectors on the
rear cable assembly panel for the interface.
Figure 24: GPI-6 interface DB-9M connector pinout shows the pin assignment of these
connectors as viewed from the frame side of the connector.
Note:
If a DB-9F is plugged into the connector labeled CH. A I/O, inputs 1 to 3 are available on that
connector.
The connector labeled CH. B I/O has inputs 4 to 6. In
Figure 27: GPI-6 interface DB-9M connector pinout , the labels on the pins apply to either
connector.
68
Eclipse HX Matrix Frame Installation Guide