User Manual
Table Of Contents
- 1 Important Safety Instructions
- 2 Introduction
- 3 Installation Overview
- 4 Locating System Components
- 5 Powering System Components
- 6 Wiring System Components
- 6.1 Using RJ-45 connectors
- 6.2 Connecting the matrix frame to a PC running EHX
- 6.3 Connecting the matrix frame to an Ethernet network
- 6.4 Connecting the matrix frame to a PC running Production Maestro Pro
- 6.5 Connecting the matrix frame to user panels
- 6.6 General Purpose Outputs (GPOs)
- 6.7 General Purpose Inputs (GPIs)
- 6.8 E & M signalling with an E-QUE E1 / T1 interface card
- 6.9 Connecting the matrix frame to an external alarm
- 6.10 Connecting to a four-wire audio device
- 6.11 Connecting to interface modules
- 6.11.1 Wiring schemes for the FOR-22 interface module
- 6.11.2 Wiring schemes for the CCI-22 interface module
- 6.11.3 Wiring for Clear-Com analog partyline systems (including Encore)
- 6.11.4 Wiring schemes for TEL-14 interface modules
- 6.11.5 Wiring scheme for the RLY-6 interface module
- 6.11.6 Wiring schemes for a GPI-6 Interface module
- 7 Connecting Matrix Frames
- 8 Glossary
Figure 25: RLY-6/GPI-6 Daisy Chain Connection
Note:
If both GPI-6 and RLY-6 interfaces are used the GPI-6 interfaces must be placed first in the
daisy chain.
RJ-45
DB-9
RJ-45
DB-9
RJ-45
DB-9
RJ-45
DB-9
RJ-45
DB-9
RJ-45
DB-9
RJ-45
DB-9
RJ-45
DB-9
GPI / RLY
interface
connector
Rear view of IMF-3 interface frame
RLY-6 #2 RLY-6 #1 GPI-6 #2 GPI-6 #1
65
Eclipse HX Matrix Frame Installation Guide