User Manual
Table Of Contents
- 1 Important Safety Instructions
- 2 Introduction
- 3 Installation Overview
- 4 Locating System Components
- 5 Powering System Components
- 6 Wiring System Components
- 6.1 Using RJ-45 connectors
- 6.2 Connecting the matrix frame to a PC running EHX
- 6.3 Connecting the matrix frame to an Ethernet network
- 6.4 Connecting the matrix frame to a PC running Production Maestro Pro
- 6.5 Connecting the matrix frame to user panels
- 6.6 General Purpose Outputs (GPOs)
- 6.7 General Purpose Inputs (GPIs)
- 6.8 E & M signalling with an E-QUE E1 / T1 interface card
- 6.9 Connecting the matrix frame to an external alarm
- 6.10 Connecting to a four-wire audio device
- 6.11 Connecting to interface modules
- 6.11.1 Wiring schemes for the FOR-22 interface module
- 6.11.2 Wiring schemes for the CCI-22 interface module
- 6.11.3 Wiring for Clear-Com analog partyline systems (including Encore)
- 6.11.4 Wiring schemes for TEL-14 interface modules
- 6.11.5 Wiring scheme for the RLY-6 interface module
- 6.11.6 Wiring schemes for a GPI-6 Interface module
- 7 Connecting Matrix Frames
- 8 Glossary
Key to Figure 20: Wiring an IMF-102 rear panel to a TEL-14 interface module
Connector
Instruction / description
A
DB-9M connector. Connects to the first telephone line, line A.
B
RJ-45 connector. Connects telephone line A to the matrix frame.
C
DB-9M connector. Connects to the second telephone line, line B.
D
RJ-45 connector. Connects telephone line B to the matrix frame.
Table 17: Key to Figure 20: Wiring an IMF-102 rear panel to a TEL-14 interface module
Note:
To allow use of a common RJ-11 terminated telephone line, Clear-Com provides two DB-9F
to RJ-11 adapters (Clear-Com part 770025).
For internal dip-switch settings and adjustments, see the TEL-14 manual.
Connecting a TEL-14 interface to the telephone line
Connecting the telephone line can be accomplished with one of two methods:
• Use the RJ-11 to DB-9F adapters supplied by Clear-Com with the TEL-14 interface
module.
• Directly wire each telephone line to a DB-9F connector using the pinouts as shown in
the following figure (which displays the wiring diagram of the RJ-11 to DB-9F
adapter).
62
Eclipse HX Matrix Frame Installation Guide