User Manual
Table Of Contents
- 1 Important Safety Instructions
- 2 Introduction
- 3 Installation Overview
- 4 Locating System Components
- 5 Powering System Components
- 6 Wiring System Components
- 6.1 Using RJ-45 connectors
- 6.2 Connecting the matrix frame to a PC running EHX
- 6.3 Connecting the matrix frame to an Ethernet network
- 6.4 Connecting the matrix frame to a PC running Production Maestro Pro
- 6.5 Connecting the matrix frame to user panels
- 6.6 General Purpose Outputs (GPOs)
- 6.7 General Purpose Inputs (GPIs)
- 6.8 E & M signalling with an E-QUE E1 / T1 interface card
- 6.9 Connecting the matrix frame to an external alarm
- 6.10 Connecting to a four-wire audio device
- 6.11 Connecting to interface modules
- 6.11.1 Wiring schemes for the FOR-22 interface module
- 6.11.2 Wiring schemes for the CCI-22 interface module
- 6.11.3 Wiring for Clear-Com analog partyline systems (including Encore)
- 6.11.4 Wiring schemes for TEL-14 interface modules
- 6.11.5 Wiring scheme for the RLY-6 interface module
- 6.11.6 Wiring schemes for a GPI-6 Interface module
- 7 Connecting Matrix Frames
- 8 Glossary
Key to Figure 19: Wiring an IMF-3 rear panel to a TEL-14 interface module
Connector
Instruction / description
A
The upper DB-9M connector is used to connect to the first telephone
line, line A.
B
The upper RJ-45 connector is then used to connect telephone line A to
the matrix frame.
C
The lower DB-9M connector is used to connect to the second telephone
line, line B.
D
The lower RJ-45 connector is used to connect telephone line B to the
matrix frame.
Table 16: Key to Figure 20; Wiring an IMF-3 rear panel to a TEL-14 interface module
Note:
To allow use of a common RJ-11 terminated telephone line, Clear-Com provides two DB-9F
to RJ-11 adapters (Clear-Com part 770025).
For internal dip-switch settings and adjustments, see the TEL-14 manual.
Wiring a TEL-14 interface to an IMF-102 interface frame
On the rear of the IMF-102, there are two sets of four connectors each, arranged
horizontally.
Figure 23: Wiring an IMF-102 rear panel assembly to a TEL-14 interface
Ch. A
Matrix
Ch. A
I / O
Ch
. B
Matrix
Ch. B
I / O
Ch. A
Matrix
Ch. A
I / O
Ch. B
Matrix
Ch. B
I / O
A
B
C
D
61
Eclipse HX Matrix Frame Installation Guide