User Manual
Table Of Contents
- 1 Important Safety Instructions
- 2 Introduction
- 3 Installation Overview
- 4 Locating System Components
- 5 Powering System Components
- 6 Wiring System Components
- 6.1 Using RJ-45 connectors
- 6.2 Connecting the matrix frame to a PC running EHX
- 6.3 Connecting the matrix frame to an Ethernet network
- 6.4 Connecting the matrix frame to a PC running Production Maestro Pro
- 6.5 Connecting the matrix frame to user panels
- 6.6 General Purpose Outputs (GPOs)
- 6.7 General Purpose Inputs (GPIs)
- 6.8 E & M signalling with an E-QUE E1 / T1 interface card
- 6.9 Connecting the matrix frame to an external alarm
- 6.10 Connecting to a four-wire audio device
- 6.11 Connecting to interface modules
- 6.11.1 Wiring schemes for the FOR-22 interface module
- 6.11.2 Wiring schemes for the CCI-22 interface module
- 6.11.3 Wiring for Clear-Com analog partyline systems (including Encore)
- 6.11.4 Wiring schemes for TEL-14 interface modules
- 6.11.5 Wiring scheme for the RLY-6 interface module
- 6.11.6 Wiring schemes for a GPI-6 Interface module
- 7 Connecting Matrix Frames
- 8 Glossary
d. Label the second control REC1.
e. Add the Radio In route to REC1.
f. Add the E & M relay / GPO (the relay associated with the first configured port
on the E1 / T1 direct E-QUE card) to REC1.
Note:
This relay receives the E & M signal from the ship’s radio into the matrix.
4. In Configuration > Cards and Ports > Frame and Module GPIs:
a. Select the appropriate E & M enabled GPI (the GPI associated with the first
configured port on the E1 / T1 direct E-QUE card).
b. In Advanced Settings, enable / select the trigger for the PTT1 control.
Note:
When the E & M signal is received from the shore-based communications
system at the E1 / T1 direct E-QUE card, the E & M signal is sent to the FOR-
22 / radio.
5. In Configuration > System Ports:
a. Select the port for the FOR-22 interface module.
b. In Advanced Settings > VOX action, select the REC1 control from the drop-
down menu.
c. In Advanced Settings > VOX action > Voice Op. Switch, adjust the Audio
Off Delay and Audio Detect Threshold as required.
Note:
When VOX is detected, the E & M signal for the FOR-22 / radio is sent via the
E1 / T1 direct E-QUE card to the shore-based communications system.
52
Eclipse HX Matrix Frame Installation Guide