User Manual
Table Of Contents
- 1 Important Safety Instructions
- 2 Introduction
- 3 Installation Overview
- 4 Locating System Components
- 5 Powering System Components
- 6 Wiring System Components
- 6.1 Using RJ-45 connectors
- 6.2 Connecting the matrix frame to a PC running EHX
- 6.3 Connecting the matrix frame to an Ethernet network
- 6.4 Connecting the matrix frame to a PC running Production Maestro Pro
- 6.5 Connecting the matrix frame to user panels
- 6.6 General Purpose Outputs (GPOs)
- 6.7 General Purpose Inputs (GPIs)
- 6.8 E & M signalling with an E-QUE E1 / T1 interface card
- 6.9 Connecting the matrix frame to an external alarm
- 6.10 Connecting to a four-wire audio device
- 6.11 Connecting to interface modules
- 6.11.1 Wiring schemes for the FOR-22 interface module
- 6.11.2 Wiring schemes for the CCI-22 interface module
- 6.11.3 Wiring for Clear-Com analog partyline systems (including Encore)
- 6.11.4 Wiring schemes for TEL-14 interface modules
- 6.11.5 Wiring scheme for the RLY-6 interface module
- 6.11.6 Wiring schemes for a GPI-6 Interface module
- 7 Connecting Matrix Frames
- 8 Glossary
Figure 11: Pin configuration of the GPO connector (DB-25M)
Note:
The general purpose outputs are single-pole double-throw relays with contact ratings of 30
VDC (volts direct current) at 1 ampere.
DB-25M connector
10
1
2
3
4
5
6
7
8
9
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
Normally open
Common
RELAY6
Normally closed
Normally open
Common
RELAY5
Normally closed
Normally closed
Normally open
Common
RELAY7
Common
RELAY8
Normally closed
Normally open
Normally open
Normally closed
Common
RELAY1
Normally closed
Common
RELAY2
Normally closed
Common
RELAY3
Normally closed
Common
RELAY4
Normally open
Normally open
Normally open
Digital ground
43
Eclipse HX Matrix Frame Installation Guide