User Manual
Table Of Contents
- 1 Important Safety Instructions
- 2 Introduction
- 3 Installation Overview
- 4 Locating System Components
- 5 Powering System Components
- 6 Wiring System Components
- 6.1 Using RJ-45 connectors
- 6.2 Connecting the matrix frame to a PC running EHX
- 6.3 Connecting the matrix frame to an Ethernet network
- 6.4 Connecting the matrix frame to a PC running Production Maestro Pro
- 6.5 Connecting the matrix frame to user panels
- 6.6 General Purpose Outputs (GPOs)
- 6.7 General Purpose Inputs (GPIs)
- 6.8 E & M signalling with an E-QUE E1 / T1 interface card
- 6.9 Connecting the matrix frame to an external alarm
- 6.10 Connecting to a four-wire audio device
- 6.11 Connecting to interface modules
- 6.11.1 Wiring schemes for the FOR-22 interface module
- 6.11.2 Wiring schemes for the CCI-22 interface module
- 6.11.3 Wiring for Clear-Com analog partyline systems (including Encore)
- 6.11.4 Wiring schemes for TEL-14 interface modules
- 6.11.5 Wiring scheme for the RLY-6 interface module
- 6.11.6 Wiring schemes for a GPI-6 Interface module
- 7 Connecting Matrix Frames
- 8 Glossary
6.4 Connecting the matrix frame to a PC running
Production Maestro Pro
Production Maestro Pro is the is a multi-user, multi-matrix PC based software package
which provides fast, intuitive audio routing control for Eclipse HX systems.
Tip: For more information, see
http://www.clearcom.com/product/digital-matrix/software/production-maestro-pro
6.4.1 LMC-64 interface card
Access to the audio level metering functionality of Production Maestro Pro is usually
achieved using the LMC-64 interface card.
For more information about the LMC-64 interface card (which you can fit to either an Eclipse
HX-Omega, Eclipse HX-Median or Eclipse HX-Delta matrix frame), see:
• The LMC-64 manual.
• The Eclipse HX-Omega User Guide.
• The Eclipse HX-Median User Guide.
• The Eclipse HX-Delta User Guide.
6.5 Connecting the matrix frame to user panels
The Eclipse HX system uses a 4-pair (analog) wiring scheme between the matrix frame and
user panels (V-Series and I-Series panels). All supported panels have built-in RJ-45
connectors.
6.5.1 4-Pair analog wiring
4-pair analog wiring is performed with shielded CAT5 RJ-45 cable:
Pair
Description
Pair 1
Transmits analog audio from the matrix to the panel.
Pair 2
Transmits digital data from the panel back to the matrix.
Pair 3
Transmits audio from the panel to the matrix.
Pair 4
Transmits digital data from the matrix back to the panel.
Table 11: 4-Pair analog wiring
39
Eclipse HX Matrix Frame Installation Guide