User Manual
Table Of Contents
- 1 Important Safety Instructions
- 2 Introduction
- 3 Installation Overview
- 4 Locating System Components
- 5 Powering System Components
- 6 Wiring System Components
- 6.1 Using RJ-45 connectors
- 6.2 Connecting the matrix frame to a PC running EHX
- 6.3 Connecting the matrix frame to an Ethernet network
- 6.4 Connecting the matrix frame to a PC running Production Maestro Pro
- 6.5 Connecting the matrix frame to user panels
- 6.6 General Purpose Outputs (GPOs)
- 6.7 General Purpose Inputs (GPIs)
- 6.8 E & M signalling with an E-QUE E1 / T1 interface card
- 6.9 Connecting the matrix frame to an external alarm
- 6.10 Connecting to a four-wire audio device
- 6.11 Connecting to interface modules
- 6.11.1 Wiring schemes for the FOR-22 interface module
- 6.11.2 Wiring schemes for the CCI-22 interface module
- 6.11.3 Wiring for Clear-Com analog partyline systems (including Encore)
- 6.11.4 Wiring schemes for TEL-14 interface modules
- 6.11.5 Wiring scheme for the RLY-6 interface module
- 6.11.6 Wiring schemes for a GPI-6 Interface module
- 7 Connecting Matrix Frames
- 8 Glossary

Contents
1 Important Safety Instructions ........................................................................... 6
Safety symbols .................................................................................................................... 7
Mains power cord ................................................................................................................ 7
2 Introduction ........................................................................................................ 8
2.1 Chapters summary ................................................................................................... 8
2.2 Further information ................................................................................................... 9
3 Installation Overview ....................................................................................... 10
3.1 Before installing the system .................................................................................... 10
3.1.1 Check the shipment ......................................................................................... 10
3.1.2 Select locations for the system components ................................................... 11
3.1.3 Determine cabling and wiring scheme requirements....................................... 11
3.2 Installing the Eclipse HX system ............................................................................ 13
3.2.1 Installing the matrix frame in a 19” rack .......................................................... 13
3.2.2 Installing the cabling ........................................................................................ 14
3.2.3 Connecting the other system components to the matrix frame ....................... 14
3.2.4 Connecting to mains AC power ....................................................................... 14
3.3 After installing the Eclipse HX system .................................................................... 15
3.3.1 Configuring the system with EHX software ..................................................... 15
3.3.2 Minimum PC requirements (for EHX software) ............................................... 16
3.3.3 Recommended PC requirements (for EHX software) ...................................... 17
3.3.4 Checking the installed system ......................................................................... 17
4 Locating System Components ..................................................................... 20
4.1 Locating Eclipse HX matrix frames ......................................................................... 20
4.1.1 Locating the Eclipse HX-Omega, Eclipse HX-Median and Eclipse HX-Delta .. 21
4.1.2 Locating the Eclipse HX-PiCo ......................................................................... 22
4.2 Locating interface frame(s) and power supplies ..................................................... 22
4.2.1 IMF-3 interface frame ...................................................................................... 22
4.2.2 IMF-102 interface frame .................................................................................. 24
4.3 Locating user panels .............................................................................................. 24
4.4 Locating the external computer for EHX ................................................................. 24
5
Powering System Components
.............................................................................. 26
3
Eclipse HX Matrix Frame Installation Guide










