User Manual
Table Of Contents
- 1 Important Safety Instructions
- 2 Introduction
- 3 Installation Overview
- 4 Locating System Components
- 5 Powering System Components
- 6 Wiring System Components
- 6.1 Using RJ-45 connectors
- 6.2 Connecting the matrix frame to a PC running EHX
- 6.3 Connecting the matrix frame to an Ethernet network
- 6.4 Connecting the matrix frame to a PC running Production Maestro Pro
- 6.5 Connecting the matrix frame to user panels
- 6.6 General Purpose Outputs (GPOs)
- 6.7 General Purpose Inputs (GPIs)
- 6.8 E & M signalling with an E-QUE E1 / T1 interface card
- 6.9 Connecting the matrix frame to an external alarm
- 6.10 Connecting to a four-wire audio device
- 6.11 Connecting to interface modules
- 6.11.1 Wiring schemes for the FOR-22 interface module
- 6.11.2 Wiring schemes for the CCI-22 interface module
- 6.11.3 Wiring for Clear-Com analog partyline systems (including Encore)
- 6.11.4 Wiring schemes for TEL-14 interface modules
- 6.11.5 Wiring scheme for the RLY-6 interface module
- 6.11.6 Wiring schemes for a GPI-6 Interface module
- 7 Connecting Matrix Frames
- 8 Glossary
3.3.2 Minimum PC requirements (for EHX software)
Specification
Description / Value
Processor
1 GHz
Memory
1GB RAM
Hard disk
1GB minimum 32 bit, 2GB minimum 64 bit.
Input devices
CD-ROM drive
Display resolution
SVGA
User entry
Keyboard, Mouse
Ports
2 serial ports and/or network IEEE 802.3 Ethernet card
Network
IEEE 802.3 Ethernet card
Operating systems
Microsoft Windows Server 2003 SP2 (32 bit and 64 bit).
Microsoft Windows Server 2003 R2 (32 bit and 64 bit).
Microsoft Windows Server 2008 SP2 (32 bit and 64 bit).
Microsoft Windows Server 2008 R2 (64 bit).*
Note:
Only 64 bit is supported, as Windows Server 2008 R2 is not
available for 32 bit.
Microsoft Windows XP SP3 (32 bit and 64 bit).
Microsoft Windows Vista SP2 (32 bit and 64 bit)
Windows 7 (32 bit and 64 bit).
Windows 8 (32 bit and 64 bit).
Table 3: Minimum PC requirements
16
Eclipse HX Matrix Frame Installation Guide