Instruction Manual

Eclipse Upgrade Reference Manual
Clear-Com Communication Systems Page 120 of 155 Part Number: 810377Z Rev 6
Figure 104 - Starting the Bootloader
12. Ensure that “Send Break Condition” is checked, then press the “Start
Bootloader” button.
13. The Original screen will reappear after a few seconds.
14. Now Press “Start” in Box 5.
15. The status bar along the bottom should display “Programming device”, and the
progress bar will show the state of the operation.
16. After about 20 seconds, “finished” should appear in the status bar. The device
has now been reprogrammed. Power cycle the Tel14 to activate the new
firmware.