Instruction manual

Clear-Com Communication Systems
Eclipse-32 Matrix Instruction Manual
3-6
Single-Pair Digital
Single-pair digital wiring is accomplished with double-shielded 24 AWG
conductor CAT-6E enhanced STP cable in the case of a DIG-2
interface or CAT5 cable for the AES-6-CX interface. Pair 1 transmits
and receives multiplexed digital and analog between the matrix frame
and the panel.
Note: Ensure that the “select” switch on the panel’s rear is in the
correct position for the intended use.
Figure 3-4: Wiring Matrix to Digital Panel Using RJ-45
WIRING GENERAL-PURPOSE OUTPUTS
The DB-25 connector labeled “GP OUT” allows connection to the
Eclipse-32 matrix’s eight double-pole double-throw (DPDT) relays with
contact ratings of 30 VDC at 1A.
Each general-purpose output has a relay inside the Eclipse-32 matrix.
When a general-purpose output is inactive, the associated “common”
pin on the GP OUT connector will be shorted to the relevant “normally
closed” pin. When a general-purpose output becomes active, the short
between the “common” pin and the “normally closed” pin is broken and
a new connection is made between the “common” pin and the
“normally open” pin.
Pair 2
Pair 1
Pair 3
Pair 4
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Matrix Frame End
ATT-T568B (Modular Jumpers Wired One to One)
Panel End
No Connection (NC)
No Connection (NC)
No Connection (NC)
Multiplexed Data/Audio
Multiplexed Data/Audio
No Connection (NC)
No Connection (NC)
No Connection (NC)
4