Instruction manual

Clear-Com Communication Systems
Eclipse-32 Matrix Instruction Manual
2-4
rightmost two switches (nearest the side of the case) simultaneously
and then press and release the ‘RESET’ button at the front of the unit,
then release the internal switches. The unit will then be reset to the
factory default IP address.
The unit cover should be replace immediately the operation is
completed.
Warning: As the unit must be powered when resetting the IP
address this operation should only be carried out by
qualified service personnel.
Figure 2-2: Eclipse-32 Reset Buttons
CONNECTING THE MATRIX TO REMOTE
DEVICES
The Eclipse-32 matrix connects to remote devices such as intercom
panels, interfaces, general purpose inputs and outputs, local area
networks, and other matrices through its rear-panel hardware
connectors.
The following sections describe the rear-panel connectors. The
Installation Chapter of this manual gives pin assignments for each
connector.