Instruction manual

Clear-Com Communication Systems

Eclipse-32 Matrix Instruction Manual

2-2

PC CONNECTOR

The female 9-pin D-type socket labeled “PC” connects the matrix to an

external computer.

RESET BUTTON

Pressing the reset button causes the matrix to stop its current activity

and to restart. The same configuration that was active before the

matrix was reset will be active after it is reset.

During the reset, configuration information reloads to the matrix’s

operational memory from its non-volatile memory and the matrix starts

running again from the beginning.

OK LIGHT

When flashing, the “OK” light indicates that the Eclipse-32 matrix is

running normally.

CONFIGURATION “CONFIG” BUTTON

The Eclipse-32 matrix can hold four complete system configurations in

its operational memory. Any one of the four configurations can be

activated using the CONFIG button on the matrix front panel.

When one of the four configurations is active, its front-panel light

illuminates steadily.

To select a new configuration

1. Repeatedly tap the CONFIG button until the desired configuration’s

light (1,2,3, or 4) starts flashing.

2. While the desired configuration’s light flashes, press and hold the

configuration button for three seconds, until the light stops flashing,

and illuminates steadily.

The selected configuration then becomes the system’s active

operational configuration.

If an invalid or blank configuration is chosen all four configuration lights

steadily illuminate at the same time for about a second. The currently

active configuration will continue to operate and its front-panel light

steadily illuminates after the other lights go out.

CONFIGURATION STATUS LIGHTS

The four configuration status lights indicate which of the four onboard

configurations is currently active. The currently active configuration’s

light illuminates steadily.