Instruction manual

Clear-Com Communication Systems
Eclipse-32 Matrix Instruction Manual
2-1
OPERATING AN
ECLIPSE-32 MATRIX
STORING AND RETRIEVING CONFIGURA-
TIONS
A “configuration map” is a complete set of operating parameters for the
matrix system which includes talk and listen paths for each connected
intercom panel. Depending upon the remote interfaces installed, the
configuration map can also include more sophisticated features such
as paging, call signaling, interrupt foldback (IFB), ISO, groups,
automatic DTMF dialing, routing, and many other features.
The system manager creates a configuration in the Eclipse
Configuration System programming software and then uploads the
configuration to the Eclipse-32 matrix’s operational memory through
the software. The Eclipse-32 matrix’s operational memory holds up to
four complete configurations. From the controls on the matrix’s front
panel the system manager may select which configuration to apply at
any given time.
In the event of a power failure, the Eclipse-32 system can
automatically restore itself to full functioning by retrieving configuration
information from its non-volatile operational memory.
FRONT-PANEL CONTROLS AND LIGHTS
Figure 2-1: Front Panel of Eclipse-32 Matrix
1
2
3
4
5
6
7
8
1 PC connector for computer
2 Reset button
3 OK light
4 Configuration ("config") button to
select among onboard configurations
5 Configuration status lights to indicate currently active
configuration
6 Power supply alarm lights (1 and 2)
7 LAN status lights
8 Port status lights
No parts of the Eclipse -32
matrix are removable without
taking the unit out of service.
2