Instruction Manual

4 Tempest®24 00 MasterBelt
Tempest ba eries are not subject to transport regula ons of dangerous goods because they ful ll the following regulatory
provisions:
» ADR 188
» IATA A45
» IMDG 188
Ba ery Storage
Long-term storage of ba eries at maximum charge can result in permanent loss of capacity.
For long term storage of ba eries, charge/discharge the ba eries to approximately 60% of capacity. Ba eries stored for
longer than one year should be recharged to 60% annually. Trickle charging is not recommended due to the very low self
discharge rate of the ba eries.
As with all ba eries:
• Do not burn.
• Do not expose ba eries to excessive heat such as sunshine,  re or other heat sources.
• CAUTION – Danger of explosion if ba ery is incorrectly replaced. Replace only with the same or equivalent type.
• Properly dispose of used ba eries promptly.
• Keep away from children.
Maintenance and Care
Cleaning
Generally, the Tempest Wireless hardware should be cleaned only with a dry cloth. A so cloth with rubbing alcohol may
be used to wipe the units if needed. Never spray solvents or chemicals onto the units.
Because of Tempest’s weather resistant design, it is not highly suscep ble to dust or airborne contaminants. However, all
electronic devices can be suscep ble to par culate contamina on. If exposed to an extremely dusty environment, contact
an authorized Tempest service center for internal cleaning.
Temperature and Humidity
Ideally, all electronics should be stored and used in a controlled environment with moderate temperature and humidity.
Tempest components are designed to be very durable, and can tolerate a wide range of environmental condi ons.
Install the MasterBelt in a loca on where it will not be exposed to extreme weather condi ons. Protect the unit against
dust or moisture. Always protect any AC power connec ons from the elements with safety in mind.
The MasterBelt and BeltSta ons are designed to work wherever people work. While the design is weather resistant, the
headset XLR connector on the bo om is not water ght. MasterBelts or BeltSta ons should not be submerged in liquids.
Protect the ba ery compartment from water when changing ba eries. The ba ery compartment off ers a route to the
electronic circuitry.