Instruction Manual

18 Tempest®24 00 MasterBelt
• Volume Limit - a minimum and maximum volume level can be set per MasterBelt or BeltSta on. In loud
environments a higher minimum volume may be desirable, while in quiet environments a lower maximum volume
may be preferable. Default se ng is OFF for both Min Volume and Max Volume.
» To set a minimum volume: Press MENU, select Set Controls>Volume Limit>Min Volume and use the volume
knob to adjust to the desired level. Press ENT to save.
» To set a maximum volume: Press MENU, select Set Controls>Volume Limit>Max Volume and use the volume
knob to adjust to the desired level. Press ENT to save.
•
Stage Announce - the Stage Announce func onality is not applicable when using BeltSta ons in a MasterBelt
applica on.
•
Call Alert - a call alert can be used to send an audible or vibra ng signal to other users’ BeltSta ons on the same
channel. A call signal is only sent when the originator’s TALK bu on is ac ve. Press MENU, select Set Controls>Call
Alert and choose either Audible, Vibrate, Both or Disable. Default se ng is Both.
•
Call Bu on - the CALL bu on is used to trigger call alerts. Press MENU, select Set Controls>Call Bu on and Enable or
Disable the bu on. Default se ng is Enable.
•
Select Relay - the relay func onality is not applicable when using BeltSta ons in a MasterBelt applica on.
•
Relay Bu on - the relay func onality is not applicable when using BeltSta ons in a MasterBelt applica on.
•
Wireless ISO - this func onality is not applicable when using BeltSta ons in a MasterBelt applica on.
•
Volume Press - the volume controls can be set to “Volume Press” which requires a “press and turn” ac on to adjust
the volume levels. This helps prevent inadvertent adjustments. Press MENU, select Set Controls>Volume Press and
Enable or Disable this feature. Default se ng is Disable.
•
Talk Tones - this is an audible tone that can be heard in the headset when the TALK bu on is pressed. Press MENU,
select Set Controls>Talk Tones and Enable or Disable this op on. Default se ng is Enable.
•
Delay Switch - when enabled this requires the channel knobs to be pressed and held slightly longer in order to
change channels. This helps prevent inadvertent adjustments. Press MENU, select Set Controls>Delay Switch and
Enable or Disable this op on. Default se ng is Disable.