Instruction Manual

13 Tempest®24 00 MasterBelt
MasterBelt Power ON/OFF
• The Power ON/OFF bu on is used to turn the MasterBelt ON or
OFF.
• Press and hold the Power ON/OFF bu on for two seconds to turn
the MasterBelt ON.
• Press and hold for four seconds to turn the MasterBelt OFF.
Selec ng a Frequency Band
The Tempest MasterBelt 2.4GHz model is approved for license free use in most countries. However, due to diff erences
in radio spectrum regula ons, a few countries require that 2.4GHz equipment limit or adjust its RF spectrum opera on.
Always determine if there are country speci c frequency restric ons that apply and select the required frequency band as
described below. Tempest performs RF frequency adjustment automa cally when you select the appropriate frequency
band from the “Tech Menu.” It is only necessary to use this feature if you use Tempest in one of the countries with special
frequency requirements. Otherwise, Band 1 should be used for maximum RF performance.
If the Tempest Wireless system is transported to a country with special requirements, navigate to the Radio Con gura on
screen in the “Tech Menu” to select the appropriate frequency band from the “Set Band” menu screen of the MasterBelt.
A er changing the frequency band selec on it is necessary to “pair” each BeltSta on with the MasterBelt so the informa on
can be transmi ed from the MasterBelt to the BeltSta on.
See the “Pairing BeltSta ons with MasterBelt” sec on of this
manual for more informa on on pairing.
MHz MHz
Avoid 802.11 b/g
Band Start End Width
1 2400 2480 80 None
2 2400 2450 50 11
3 2423 2473 50 1
4 2431 2480 49 1, 2,
5 2400 2428 28 7, 8, 9, 10, 11
6 2423 2450 27 1, 11
7 2453 2480 27 1, 2, 3, 4, 5, 6, 7