Instruction Manual

10 Tempest®24 00 MasterBelt

Talk Bu on A and B

There are two TALK bu ons on each BeltSta on, one for

channel A and the other for channel B . The Talk bu on

enables the microphone signal for the assigned intercom

channels.

Tempest uses an intelligent latching method for TALK

bu ons. Pressing the TALK bu on momentarily will cause

the TALK bu on to latch. Pressing and holding the TALK

bu on will cause the bu on to act as a momentary switch.

Talk tones can be enabled or disabled per BeltSta on. If

enabled, users will here a tone each  me the TALK bu on

is pressed.

Channel Indicator LEDs A and B

Each Talk bu on has two individual LED indicators. Together they surround the

Talk bu on. The LEDs will ﬂ ash blue to indicate which intercom channel, A or

B , has been selected and will illuminate con nuously to indicate that “Talk” is

enabled on that channel.

The Channel Indicator LEDs will ﬂ ash red when the microphone signal is reaching a peak level and is entering into limi ng.

BeltSta on Display Overview

1. RSS Indicator - indicates the Radio Signal Strength of the

BeltSta on’s internal radio.

2. Battery Alert - indicates that the ba ery alert is enabled or

disabled (shown as enabled).

3. Battery Status - visual indicator of ba ery level.

4. Battery Time - the opera onal  me remaining on the ba ery.

5. MasterBelt Name - the name assigned to the MasterBelt.

6. BeltStation Name - the name assigned to the BeltSta on.

7. Channel Indicators - available channels and ac ve channel

shown with surrounding box.

8. Talk Status - TALK is displayed when latched/pressed.

2 3