Owner`s manual

CleanShot TM 2050 PSI Pressure Washer
CleanShor
TROUBLESHOOTING
Problem
Pump has following problems:
failure to produce pressure, erratic
pressure, chattering, loss of
pressure, low water volume.
Detergent fails to mix with spray.
Cause
I. Nozzle in low pressure mode.
2. Water inlet isblocked.
3. Inadequatewater supply.
4. Inlet hose iskinked or leaking.
5. Clogged inlet hose strainer.
6. Water supply is over 100°E
7. High pressure hose isblocked or
leaks.
8. Gun leaks.
9. Nozzle isobstructed.
10. Pump is faulty.
I.
2.
3.
4.
Detergent siphoning tube isnot
submerged.
Chemical filter isclogged or
cracked.
Dirty in-line filter.
Nozzle is in high pressure mode.
Correction
I. Pull nozzle backward for high
pressure mode.
2. Clear inlet.
3. Provide adequate water flow.
4. Straighten inlet hose, patch leak.
5. Check and clean inlet hose
strainer.
6. Provide cooler water supply.
7. Clear blocks in outlet hose.
8. Replacegun.
9. Clean nozzle.
10. Contact Briggs and Stratton Power
Products service facility.
I. Insert detergentsiphoning tube
into detergent.
2. Clean or replace filter/detergent
siphoning tube.
3. See"Check In-Line Filter".
4. Push nozzle forward for low
pressure mode.
Engine speed istoo slow. Move throttle control to FAST
Engine runs good at no-load but position. If engine still "bogs down",
"bogs" when load is added, contact Briggsand Stratton service
facility.
Pressure washer stops during Out of gasoline. Fill fuel tank.
operation.
/
15