Owner`s manual

CleanShotTM 2050 PSI PressureWasher
CleanShot
4. Attach the brush with the adapter to the spray gun.
Tighten by hand (Figure 10).
NOTE:You must usethe adapter to attach the brush to
the spray gun.
5. Disengagesafety latch to spray gun trigger.
Applying Detergent with the
Adjustable Nozzle
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
CAUTION
• Starting the engine without all the hoses connected and
without the water turned ON will damagethe pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
To apply detergent, follow these steps:
I. Review use of adjustable nozzles.
2. Prepare detergent solution as required by job.
3. Placefilter end of chemical injection hose into
detergent container.
CAUTION
• When inserting the filter into a detergent solution bottle,
route the tube so as to keep it from inadvertentlycontacting
the hot mufflen
4. Slide adjustable nozzle forward to low pressure mode.
Detergent cannot be applied with nozzle in high
pressure position.
5. Make sure garden hose is connected to water inlet.
Check that high pressure hose isconnected to spray
gun and pump. Start engine.
6. Apply detergent to a dry surface,starting at lower
portion of area to be washed and work upward, using
long, even,overlapping strokes.
7. Allow detergent to "soak in"for 3-5 minutes before
washingand rinsing. Reapplyas needed to prevent
surface from drying. DO NOT allow detergent to dry
on (prevents streaking).
IMPORTANT:You must flush the chemical injection
system after each use by placing the filter into a bucket of
clean water, then run the pressure washer in low pressure
for I-2 minutes.
Pressure Washer Rinsing
For Rinsing:
I. Slide the nozzle backward to high pressure, pressthe
trigger and wait for the detergent to clear.
NOTE:You can also stop detergent from flowingby simply
removing chemical injection hose from bottle.
2. Keep the spraygun a safe distance from the area you
plan to spray.
WARNING
Keep spray nozzle between 8 to 24 inchesawayfrom cleaning
surface.
Operate this unit on a stable surface.
Be extremely careful if you must usethe pressure washer from
a ladder,scaffolding or anyother relatively unstable location.
Firmlygrasp spraygun with both handswhen using high
pressure spray to avoid iniuryif gun kicks bac!c
3. Apply a high pressure spray to a small area,then check
the surface for damage.If no damageis found, it is okay
to continuecleaning.
4. Start at the top of the areato be rinsed,working
down with same overlapping strokes as you used for
washingand applying detergent
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressingthe trigger on the spray gun,
circulating water in the pump can reach temperatures
above 125°EThe system engagesto cool the pump by
discharging the warm water onto the ground.
/
10