Operation Manual

Emptying the Dust Container

1. Hold the device over an open dustbin.

2. Press the release button to open the dust container. The

bottom of the dust container will open and the dirt will fall out.

3. Then ﬂ ip the dust container ﬂ ap closed again. The fastener

must be heard to engage in place.

4. If necessary, you can rinse the dust container with clear,

lukewarm water. To do this, remove the dust container

from the device (see the „Cleaning the HEPA Filter“

chapter).

Cleaning the HEPA Filter

1. Remove the ﬂ oor or tile nozzle as de-

scribed in the chapter “Connecting

the Crevice Nozzle / Brush Vacuum

Floor Nozzle”.

2. Turn the dust bin slightly to the left to

remove it from the main unit.

3. Pull out the dust ﬁ lter insert together

with the HEPA ﬁ lter.

4. Take the HEPA ﬁ lter out of the dust ﬁ lter insert

5. Tap out the HEPA ﬁ lter.

6. If necessary, thoroughly rinse the HEPA ﬁ lter and the dust ﬁ lter insert with clear,

lukewarm water. CAUTION: Do not under any circumstances clean the ﬁ lter in a wa-

shing machine or dishwasher! Then shake off any excess water and let the ﬁ lter and

the ﬁ lter protective frame dry completely in the air before you insert them both again.

7. Place the HEPA ﬁ lter back onto the dust ﬁ lter insert.

8. Insert the dust ﬁ lter insert together with the HEPA ﬁ lter back into the dust container

and turn it tight.

9. Then place the dust container back into the device. Make sure that the dust contai-

ner locks in place correctly.

Cleaning the Brush nozzle

1. To make it easy to clean the brush nozzle, you can open

the nozzle: Open the dust compartment on the bottom of

the nozzle by pushing both hooks in.