Operation Manual

2. Hold the dust bin over an open garbage bin.

3. Push down on the dust bin fastener. The container lid will open and you can empty

the container.

4. Close the lid of the dust bin. The fastener must lock into place. Help closing the lid if

necessary by pushing the fastener up against the dust bin lid.

5. Depress and hold the release button and put the dust bin

back in the vacuum cleaner. The dust bin has been pro-

perly positioned when the release button pin (C) is located

under the bracket (D) on the vacuum cleaner housing (see

ﬁ gure).

Cleaning the motor ﬁ lter

1. Remove the dust bin (see section “Emptying the dust bin”).

The motor ﬁ lter (1) is located behind the dust bin in the

vacuum cleaner housing. It is protected by a foam ﬁ lter.

2. Remove the foam ﬁ lter.

3. Turn the frame with the ﬁ lter counterclockwise and re-

move it. Reach into the two recesses on the frame in or-

der to rotate and remove the frame.

4. Shake out the ﬁ lter over an open garbage can.

5. If needed, clean the ﬁ lter with clear, lukewarm water and

allow it to dry completely. Do not insert the ﬁ lter if it is still

moist.

6. Place the frame with the ﬁ lter back in the vacuum cleaner

housing and turn it clockwise to secure it. Reach into the

two recesses on the frame as when removing it.

7. The motor ﬁ lter is in place when the frame is ﬂ ush with

the vacuum cleaner housing and the recesses on the

frame are perpendicular to the bracket (D) on the vacuum

cleaner housing and are vertically in line with one another

(see ﬁ gure).

Cleaning the exhaust ﬁ lter

1. Open the exhaust ﬂ ap on the back of the vacuum cleaner. The exhaust ﬁ lter is loca-

ted behind the exhaust ﬂ ap.

2. Remove the exhaust ﬁ lter.