Operation Manual

To remove the cleaning head, depress the catch and pull the cleaning

head out at the same time.

• If you would like to use one of the other enclosed nozzles, it must ﬁ rst be attached to the

nozzle adapter (G):

• An arrow is embossed on the end piece of the nozzle and the

nozzle adapter. Connect the two parts so that the arrows are

pointing towards one another and then turn the nozzle to the

stop.

• To remove the nozzle, turn it back until the arrows on the nozzle

and adapter are pointing towards one another and pull it out.

• The nozzle adapter will be attached to the main unit in the exact same manner as the cleaning

head: Insert it in the steam nozzle until the catch audibly locks into place.

• To remove the nozzle adapter, depress the catch and pull the adapter out at the same time.

Attaching the ﬂ oor pad and carpet cleaning head

• The ﬂ oor pad (L) is attached to the cleaning head with Velcro straps.

Place it on the cleaning head and push it ﬁ rmly. After use, simply pull it

off of the cleaning head.

• To clean carpets, place the carpet cleaning head (O) ﬂ at on the ﬂ oor

and place the cleaning head with the ﬂ oor pad in the carpet cleaning

head.

Filling the water tank

ATTENTION!

❐ Always turn off the appliance before you ﬁ ll the water tank.

❐ Never ﬁ ll the appliance with cleaners or other additives. They may irreparably damage the

appliance and as such, the safe operation of the appliance can no longer be assured.

If the power LEDs (12) are blinking red, the water tank (7) is empty and has to be ﬁ lled.

We recommend that, ideally, you ﬁ ll the water tank with distilled water to prevent

calciﬁ cation, especially if the hardness of your tap water is very high.