Operation Manual

21 EN

Cleaning the Device and Accessories

ATTENTION!

■ Empty the dust container when it reaches the Max mark and clean the cyclone insert

and ﬁ lters regularly in order to prevent the motor from overheating.

■ Prior to cleaning the device, always pull the mains plug out of the socket.

■ Keep the device, the mains cable and the mains plug away from water or other liq-

uids in order to avoid the risk of electrical shock. When cleaning the vacuum cleaner

make sure that no liquid gets into the device. Only the ﬁ lters may be cleaned with

water. However, when ﬁ tted back into the device they must be completely dry.

■ The ﬁ lters are not suitable for the washing machine, dishwasher or dryer! Only air

dry the ﬁ lters and do not under any circumstances use a hair dryer.

■ Do not use any corrosive or abrasive cleaners or cleaning pads for cleaning. They

could damage the surface.

Over time the ﬁ lters may become discoloured. This is normal and does not

affect the functionality.

Emptying the Dust Container

1. Hold the dust container handle and pull the dust container

out of the motor unit.

2. Hold the dust container over an open dustbin. The dis-

tance between the dust container and the dustbin should

be as short as possible to ensure that the dust from the

dust container falls into the dustbin only and does not spill

into the environment.

3. Press the button to open the dust container (12) (to the

side). The bottom of the dust container will open and the

dirt will fall out.

4. Close the bottom of the dust container again. The fasten-

er must be heard to engage in place.

5. Plug the closed dust container into the motor unit until it is

heard to engage in the locking mechanism.

Cleaning the Cyclone Insert and Motor Filters

The cyclone insert is located in the dust container. The motor ﬁ lters are seated in the

ﬁ lter holder on the cyclone insert.

1. Remove the dust container from the device and empty it (see the “Emptying the Dust

Container” section).

2. Turn the lid of the dust container as far as it will go in an anticlockwise direction.

When the line marked on the edge of the lid is next to the

symbol on the dust

container, remove the lid.

3. Pull the ﬁ lter holder (13) off the cyclone insert (15) and

remove the foam ﬁ lter (14).

Please note: The ﬂ eece ﬁ lter is attached to the ﬁ lter hold-

er and cannot be taken out of the holder!

4. Carefully remove the cyclone insert from the dust con-

tainer.

13 1514