Operation Manual

31 EN

Cleaning the HEPA Filter

The HEPA ﬁ lter is located in the ﬁ lter unit in the dust container and should be cleaned

regularly to ensure that the suction power of your vacuum cleaner does not diminish and

the motor is not overloaded.

1. Hold down the release button on the handle of the dust

container and detach the dust container from the vacuum

cleaner.

2. Open the dust container by releasing the fastener clip (A)

and folding up the dust container lid.

3. Remove the HEPA ﬁ lter (B) by pulling it out.

4. Below the HEPA ﬁ lter there is another foam ﬁ lter. Remove

it for cleaning.

5. Tap the HEPA dust ﬁ lter out over an open dustbin. Clean

the ﬁ lter using a brush if necessary. Never clean the

HEPA ﬁ lter with water to prevent damage to the ﬁ lter!

6. Tap the foam ﬁ lter out over an open dustbin. If necessary,

you can rinse the foam ﬁ lter with clear, cold water. Then

allow the ﬁ lter to dry completely before you insert it again.

7. Place the dry foam ﬁ lter back into the ﬁ lter unit.

8. Insert the HEPA ﬁ lter back into the ﬁ lter unit.

9. Close the dust container lid. The fastener clip must be heard to lock in place.

10. Insert the dust container back into the vacuum cleaner.

The dust container must be heard to engage in place.