Operation Manual

21 EN

1. Pull out the length of mains cord that you need. Do not forcefully pull the cord out

up to the stop. Do not pull it out any further than to the red mark. The yellow mark

indicates the ideal cord length.

2. Connect the mains plug to a properly installed socket.

3. Press the On/Off switch to turn the vacuum cleaner on.

4. Move the nozzle over the surface you want to clean.

5. After vacuum cleaning, press the On/Off switch to turn off the vacuum cleaner.

6. Remove the power plug from the socket. Firmly hold the mains cord and push the

button to recoil the mains cord. By holding the cord, you prevent it from “whiplashing”

against body parts such as your legs.

Cleaning

ATTENTION!

• Always pull the mains plug out of the socket before cleaning the ﬁ lters and emptying

the dust bin.

• Do not use any corrosive or abrasive cleaning agents or cleaning pads to clean the

vacuum cleaner housing. They could damage the surface.

Emptying the dust bin

1. Depress the release button and at the same time, pull the dust bin out from above.

2. Hold the dust bin over an open garbage bin.

3. Push down on the dust bin fastener. The container lid will open and you can empty

the container.

4. Close the lid of the dust bin. The fastener must lock into place. Help closing the lid if

necessary by pushing the fastener up against the dust bin lid.

5. Depress and hold the release button and put the dust bin

back in the vacuum cleaner. The dust bin has been prop-

erly positioned when the release button pin (C) is located

under the bracket (D) on the vacuum cleaner housing (see

ﬁ gure).

Cleaning the motor ﬁ lter

1. Remove the dust bin (see section “Emptying the dust bin”).

The motor ﬁ lter (1) is located behind the dust bin in the

vacuum cleaner housing. It is protected by a foam ﬁ lter.

2. Remove the foam ﬁ lter.

07420_DE-EN_FR-NL_A5_V1.indb 2107420_DE-EN_FR-NL_A5_V1.indb 21 15.07.2015 09:19:1115.07.2015 09:19:11