Operation Manual

22
2. Empty the dirty water reservoir (11). To do so, fold up the hand and pull the reservoir out
of the base (10) of the device.
3. The cap is on the back of the reservoir. Turn it 90 °
counterclockwise to open it.
4. Pour out the dirty water and rinse the reservoir out thoroughly
with warm water (max. 40 °C).
5. The exhaust air fi lter is located at the top of the dirty water
reservoir. Press the locking mechanism outward toward the
fi lter and remove the fi lter mount.
6. Take the fi lter out of the holder and rinse it off with warm
water.
7. Take the protective motor fi lter out of the main unit and rinse
it off with warm water.
8. Pour the leftover cleaning solution out of the fresh water
reservoir and clean the reservoir thoroughly with warm water.
9. As required, wipe down the device with a moist cloth.
10. Remove hair and dirt from the brush on the bottom of the device. To do so, lay the device
horizontally on the fl oor. Pay attention that the dirty water and the fresh water reservoirs
are empty or have been taken out. The water could leak out of the water reservoirs.
11. Let all parts of the device (even the brush on the bottom of the device) dry completely
before storing it.
Technical Data
Model No.: VC-9387S-7
Article No.: Z 01096
Voltage supply: 220–240 V~ 50 / 60 Hz
Motor power: 700 W
Capacity of the fresh water reservoir: max. 2 l
Capacity of the dirty water reservoir: max. 1.8 l
Safety class: II