Operation Manual

Troubleshooting

If the device should stop working properly, ﬁ rst check whether you are able to correct the

problem yourself. If you are not, contact the customer service department (see the "Cus-

tomer Service" chapter).

Do not try to repair a faulty device yourself!

Problem Possible cause/solution

The device generates no suc-

tion.

• Is the plug inserted in the mains socket correctly?

• Is the mains socket defective? Try another mains

socket.

• Check the fuse of your mains connection.

• Is the device switched on? Press the On/Off button.

Low suction force.

• Is the exhaust air valve in the handle open? Close it.

• Adjust the suction strength on the suction strength

control.

• Is the dust container full? Empty the dust container.

• Is the HEPA ﬁ lter or one of the other ﬁ lters clogged

up? Clean the ﬁ lters.

• Is the nozzle, the telescopic tube or the suction hose

clogged? Pull the mains plug out of the socket and

remove the objects causing the blockage from the

nozzle, telescopic tube and/or suction hose.

Dust escapes from the device

during cleaning.

Check whether the HEPA dust ﬁ lter is inserted into the

dust container correctly and whether the dust container

is closed and inserted correctly. Correct this if necessary.

Unusual odour

A new odour is normal when the device is used for the

ﬁ rst time and this does not indicate a defect with the

device. The odour will disappear after a little while.

Technical Data

Model: KPA08EP-05

Device: “cleanmaxx” Cyclone Vacuum Cleaner Power Pro

Voltage supply: 220 – 240 V~ 50/60 Hz

Output: 2000 W

Protection class: II