Operation Manual

Cleaning the HEPA Filter

The HEPA ﬁ lter is located in the ﬁ lter unit in the dust container and should be cleaned

regularly to ensure that the suction power of your vacuum cleaner does not diminish and the

motor is not overloaded.

1. Hold down the release button on the handle of the dust

container and detach the dust container from the vacuum

cleaner.

2. Open the dust container by releasing the fastener clip (A)

and folding up the dust container lid.

3. Remove the HEPA ﬁ lter (B) by pulling it out.

4. Below the HEPA ﬁ lter there is another foam ﬁ lter. Remove it

for cleaning.

5. Tap the HEPA dust ﬁ lter out over an open dustbin. Clean the ﬁ lter using a brush if neces-

sary. Never clean the HEPA ﬁ lter with water to prevent damage to the ﬁ lter!

6. Tap the foam ﬁ lter out over an open dustbin. If necessary, you can rinse the foam ﬁ lter

with clear, cold water. Then allow the ﬁ lter to dry completely before you insert it again.

7. Place the dry foam ﬁ lter back into the ﬁ lter unit.

8. Insert the HEPA ﬁ lter back into the ﬁ lter unit.

9. Close the dust container lid. The fastener clip must be heard to lock in place.