Instructions
19 EN
Use
PLEASE NOTE!
■ Empty and clean the collecting container after each use or when the maximal fi ll
level (MAX marking) is reached. Do not overfi ll the collecting container!
■ Test the wiping attachment on a non-visible spot before using it on sensitive (high-
gloss) surfaces.
■ Never clean screens (televisions, computer monitors etc.) with the device. Electrical
devices of this type are not resistant to moisture.
■ Switch on the device only once you have ensured that the suction nozzle has been
inserted correctly.
■ Always switch the device off fi rst before you remove the nozzle!
■ Do not use the device when it is connected to the mains power supply.
1. Press the On / Off switch (1) to switch on the device. The operating lamp lights up
blue. The normal suction mode is switched on.
2. Press the On / Off switch again to switch to strong suction mode. The operating lamp
lights up red.
3. Guide the nozzle (4) over the surface to be cleaned from
top to bottom. During use, check whether the collecting
container (5) is full. If this is the case, it needs to be
emptied.
4. Hold down the On / Off switch for around 3-5 seconds to
switch off the device.
5. To ensure optimum performance of the device, empty the
collecting container after every use (see the “Cleaning
and Storage” chapter) and charge up the battery (see the
“Charging Up the Battery“ chapter).
Use of the Spray Bottle with Wiping Attachment
1. Fill the spray bottle: Unscrew the spray head from the spray bottle and fi ll the bottle
with cleaning agent and water in accordance with the manufacturer's specifi cations.
2. Place the wiping attachment (a) onto the spray head (b):
To do this, press together the locking lugs on the wiping
attachment and plug them into the holder on the spray
head. They must fi rmly engage.
3. Stretch the wiping cloth (d) onto the wiping attachment
with the aid of the rubber loops and secure it in place with
the Velcro fastener.
4. Close the bottle again.
5. Move the spray nozzle to SPRAY (spray mist) or STREAM.
6. Spray the cleaning product evenly onto the surface which is to be cleaned. To do
this, press the spray lever (c) of the bottle.
7. Detach the dirt using the wiping cloth. Note: If necessary, rinse out the wiping cloth
under running water!
8. Suck the cleaning liquid up from the surface using the device.
c
b
a
d
02304_02930_DE-EN-FR-NL_A5_V9.indb 1902304_02930_DE-EN-FR-NL_A5_V9.indb 19 30.09.2021 08:59:4530.09.2021 08:59:45