User manual

13 EN

■ Protect the device from heat, naked ﬂ ames, extreme temperatures, persistent mois-

ture, wet conditions and collisions.

■ Do not use any corrosive or abrasive cleaning agents to clean the device. These can

damage the surface.

Items Supplied and Device Overview

Unpack the items supplied and check them for completeness (see the “Items Supplied

and Device Overview” chapter) and possible transport damage. If the device, the mains

plug or the mains cable does have damage, do not use the device(!), but contact our

customer service department.

1 Hanger

2 Telescopic rod with drip protection

3 Fan

4 Motor unit

5 Ventilation slots

6 Timer (5 – 30 minutes)

7 Mounting ﬂ ange

8 Clip (for adjusting the height)

9 Collar section

Not shown:

• Nylon balloon

• 5 x clamps with integrated weight

• Mains cable with mains plug

Before Initial Use

Before using the device, remove all packaging materials and any labels that may be on

the device and are used for protection during transportation or for advertising.

Assembly

1. Plug the telescopic rod (2) into the recess on the top of the motor unit (4).

2. Place the hanger (1) onto the telescopic rod (2). When you do this, make sure that

the slight bend in the hanger (1) points forwards.

3. Attach the nylon balloon:

– Pull it over the hanger (1). When you do this, make sure that the side with the hole

line points forwards.

– Pull the small elastic cord at the top over the collar section (9) on the hanger (1).

– Pull the large elastic cord at the bottom over the mounting ﬂ ange (7).

The device is disassembled in the reverse order.

00384_DE-EN-FR-NL_A5_V3.1.indb 1300384_DE-EN-FR-NL_A5_V3.1.indb 13 01.09.2017 10:26:4401.09.2017 10:26:44