Operating instructions

How to Replace the Vacuum Belt
CAUTION: Unplug the vacuum cleaner before performing any of
these steps.
How to Remove the Bottom Plate
1. Place the vacuum cleaner in the low position (see page 6).
Turn the vacuum over.
2. Slide the clips toward each other (Fig. 1).
3. Remove the bottom plate.
How to Replace the Belt
1. Turn the unit over and remove the bottom plate as described in the
above section.
2. Lift the belt cover and turn toward the outside (Fig. 2 & 3).
3. Remove the agitator by pulling it straight out.
4. Remove the belt from the agitator and motor pulley.
5. Loop a new belt over the motor pulley and over the end of
the agitator.
6. Stretch the belt over the agitator while inserting it back into the
nozzle housing.
7. Turn the belt cover back over the motor pulley. Make sure cover
releases down into the nozzle.
8. Replace the bottom plate by hooking the front end of the plate into the
two ribs on the front end of the nozzle housing. Press the bottom plate
into place by sliding the clips away from each other.
NOTE: To ensure maximum cleaning efficiency, check the belt regularly to
ensure it is in good condition. Replace the belt if it is stretched,
cracked or if excessive slipping is occurring.
8
Fig. 1
Fig. 2
Fig. 3