Operating instructions

Handle Adjustments
6
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Filters
Your CleanMax vacuum cleaner is equipped with a secondary filter and either a post
filter or a HEPA filter. These filters capture fine dust particles and protect the motor
from dirt. It is important to change the filters regularly — approximately once a year,
or as needed.
To Change the Secondary Filter
1. Unplug the vacuum cleaner. Remove the bag compartment cover and the bag.
2. Remove the secondary filter and replace with a new filter (Fig. 5).
3. Replace the bag and bag compartment cover.
NOTE: HEPA filters cannot be washed and used again.
T
o Change the Foam Filter
1. Unplug the vacuum cleaner. Remove the bag compartment cover.
2. Remove the foam filter from the front of the bag compartment (Fig. 6).
3. DO NOT THROW AWAY THE FILTER HOLDER.
4. Insert a new filter into the holder and replace the bag compartment cover.
T
o Change the HEP
A Filter
1. Unplug the vacuum cleaner. Remove the bag compartment cover.
2. Remove the HEP
A filter from the front of the bag compar
tment (Fig. 6).
3. Inser
t a new filter and replace the bag compartment cover.
Fig. 5
Fig. 6
The handle on this vacuum cleaner can be set to one of three positions – upright, middle or low.
How to Adjust the Handle
1
. To release the handle, step on the left rear corner of the vacuum cleaner (Fig.1).
2. Upright position – for when cleaning tools are being used or for storage (Fig 2).
Handle locks in this position.
3. Middle position – for normal cleaning (Fig. 3).
4. Low position – for cleaning under furniture (Fig. 4).
*Once in the middle postion, step on the left rear corner of the vacuum
and pull back the handle again to place the vacuum to the low position.