Safety Information

Report No. 200501897SHA-001
CleanForce Environmental Protection Technology Co., Ltd.
Issued: 15-Jul-2020
Revised: None
2. Mechanical Assembly
- Components such as switches, fuseholders, connectors, wiring terminals and display
lamps are mounted and prevented from shifting or rotating by the use of lockwashers, starwashers, or other
mounting format that prevents turning of the component.
3. Corrosion Protection - All ferrous metal parts are protected against corrosion by painting, plating or the
equivalent.
4. Accessibility of Live Parts
- All uninsulated live parts in primary circuitry are housed within a non-metallic
enclosure constructed with no openings other than those specifically described in Sections 4 and 5.
5. Grounding - This product is not provided with a means of grounding as it is not required to be grounded
since the product is a portable appliance rated 120V.
6. Polarized Connection - This product is provided with a polarized power supply connection. All single pole
switches and fuses are connected only to the ungrounded supply circuit conductor.
7. Internal Wiring
- Internal wiring is routed away from sharp or moving parts. Internal wiring leads terminating
in soldered connections are made mechanically secure prior to soldering. Recognized Component
separable (quick disconnect) connectors of the positive detent type, closed loop connectors, or other types
specifically described in the text of this report are also acceptable as internal wiring terminals. At points
where internal wiring passes through metal walls or partitions, the wiring insulation is protected against
abrasion or damage by plastic bushings or grommets. All wiring is minimum 22 AWG, with a minimum rating
of 300V, 105°C.
8. Schematics
- N/A
9. Markings
- The product is marked on a labeling system as described in item No. 21 of Section 4.0 as follows:
applicant's name, brand name, model number, date of manufacturer, electrical ratings.
Refer to Illustration No. 1 for details.
10. Cautionary Markings - NA
11. Installation, Operating and Safety Instructions
- Instructions for installation and use of this product are
provided by the manufacturer. Refer to Illustration No. 2, 2a and 2b for details. Only representative pages
are pasted.
Critical Features/Components
- An essential part, material, subassembly, system, software, or accessory of a
product that has a direct bearing on the product’s conformance to applicable requirements of the product
standard.
Construction Details
- For specific construction details, reference should be made to the photographs and
descriptions. All dimensions are approximate unless specified as exact or within a tolerance. In addition to the
specific construction details described in this Report, the following general requirements also apply.
Recognized Component
- A component part, which has been previously evaluated by an accredited certification
body with restrictions and must be evaluated as part of the basic product considering the restrictions as specified
by the Conditions of Acceptability.
6.0 Critical Features
Unlisted Component - A part that has not been previously evaluated to the appropriate designated component
standard. It may also be a Listed or Recognized component that is being used outside of its evaluated Listing or
component recognition.
1. Spacing - In primary circuits, 1.6 mm minimum spacing are maintained through air and over surfaces of
insulating material between current-carrying parts of opposite polarity and 3.2 mm minimum between such
current-carrying parts and dead-metal parts or low voltage isolated circuits.
Listed Component - A component part, which has been previously Listed or Certified by an accredited
Certification Organization with no restrictions and is used in the intended application within its ratings.
ED 16.3.15 (20-Apr-17) Mandatory