Use and Care Manual

CLEANING AND MAINTENANCE

Water Filter Screen

The pressure washer is equipped with a water inlet lter screen to protect the pump. If the

screen is not kept clean, the ow of water to the pressure washer will be restricted and the

pump may be damaged.

A clogged water lter screen can cause excessive pressure to build-up in the pressure

washer’s pump. The wand’s water lter screen should be cleaned regularly to avoid

damaging the wand or pump.

1. Using needle-nose pliers, carefully take the water lter screen out of the wand.

2. Clean the water lter screen by carefully inserting the water lter cleaning tool

provided or a thin and sharp instrument (e.g. paperclip) into the lter to remove any

dirt deposited. Rinse with clean water.

3. Using needle-nose pliers, carefully reinsert the water lter screen into the wand.

Ensure the screen ts tightly into the wand’s water inlet opening.

Main body cleaning

Use only mild soap and damp cloth to clean the main body.

Warning

Never use the unit to clean itself.

Connections

Connections on pressure washer hoses, gun and spray wand should be cleaned regularly

and lubricated with non-water soluble grease.

Spray Tips Only

Clogging of the spray tips causes the pump pressure to be too high and cleaning is

immediately required. Clean the spray tips by carefully inserting a needle provided or a thin

and sharp instrument (e.g. paperclip) into the tip to remove any dirt deposited.

1. To clean inner water screen, remove the

inlet adaptor and remove the lter screen

from the pump inlet.

2. Rinse screen until it is free of debris and

blockage.

3. Replace screen immediately to prevent

any foreign matter from entering the

pump.

Warning

To assure product safety and

reliability, repairs should be

performed by authorized service

centers or other qualiﬁed service

personnel, always use identical

replacement parts.