Use and Care Manual

PARTS AND DIAGRAM LIST
Item No. Quantity Part Name
A 1 Adjustable wand
B 1 Spray gun
C 1 High-pressure hose
*D 1 Water filter
E 1 Upper handle
F 1 Detergent tank assembly
G 1 Lower handle
H 1 Hose bracket
I 1 Gun holder
J1
Power cord bracket
K1
Needle (for nozzle cleaning)
* Water filter come pre-attached on the water inlet, located on the front of the pressure washer.
E
D
C
B
A
G
H
I
J
F
Surface Preparation
Before starting any cleaning task, it is important to inspect the area for objects that could
create a hazard. Remove any objects from the work area that could be tripped over, such as
toys or outdoor furniture. Ensure that all doors and windows are closed tightly.
Water Supply (ColdWater Only)
Only draw water through the unit. For use with cold water supply only. Garden hose must be
at least a 1/2” (13 mm) in diameter. Flow rate of water supply must not fall below 2 GPM
(gallons per minute) [9.1 lpm (litres per minute)]. Flow rate can be determined by running
the
temperature must not exceed 104°F (40°C).
water for one minute into an empty 5-gallon (19 L) container The water supply .
CAUTION
t Never use the pressure washer to draw in water contaminated with solvents (e.g.
paint thinners, gasoline, oil, etc.).
t Dirt in the water inlet will damage the unit.To avoid this risk, we recommend checking
the water
(located inside the water inlet.To clean it out see Maintenance section).
t Always prevent debris from being drawn into the unit by using a clean water source
and an additional accessory water
if required.
t To prolong the life of the unit, rest the unit for 5 minutes after every 30 minutes of use.
ASSEMBLY AND OPERATING INSTRUCTIONS
K
Attach gun holder and power cord bracket. Place the upper handle into the recesses
and push forward until it audibly locks in.
5 English English 6
2
1